送絲機軟件說明:版本306(中英)

本文闡述版本號為306的軟件說明,您可以通過設置頁面查看系統版本后三位

This document describes the software version 306. You can view the last three digits of the system version on the Settings page


在此頁面可以直接調整送絲速度,通過上下鍵調整

1.首頁數值顯示送絲速度,通過上下鍵來調整,使用時請保持運行狀態

2.手動送絲:按住以后,送絲機開始送絲,手動送絲速度取決去后臺設置

3.手動回抽:按住以后,送絲機開始回抽,手動回抽速度取決于后臺設置

On this page, the wire feed speed can be adjusted directly by the up and down keys


1. The value on the home page shows the wire feed speed, which is adjusted by the up and down keys. Please keep the running state when using


2. Manual wire feeding: After holding down, the wire feeder starts to feed, and the manual wire feeding speed depends on the background setting


3. Manual pumping: After holding down, the wire feeder begins to pump back, and the manual pumping speed depends on the background setting




其他參數默認,一般只調整回抽長度和補絲長度


4.設置頁面所有設置完成后都要點擊一下保存

5.設置頁面的送絲速度為默認送絲速度,即在此處更改后,開關機仍然保持不變

6.啟動延遲:默認不設置

7;回抽長度和補絲長度:依照實際使用情況設置

當停止送絲后,系統會首先回抽一定的距離然后在送絲一定的距離,這個功能主要用于斷絲

當出現每次焊接開始絲仍然在外面的情況,請設置回抽長度大于補絲長度即可

Other parameters default, generally adjust only the length of the draw back and the length of the wire




4. Click to save all Settings on the Settings page


5. Set the wire feed speed of the page as the default wire feed speed, that is, after changing here, the switch still remains unchanged


6. Startup delay: This parameter is not set by default


7. Drawing length and filling length: set according to the actual use


When the wire feed is stopped, the system will first pump back a certain distance and then a certain distance in the wire feed, this function is mainly used for breaking the wire


When the wire is still outside at the beginning of each welding, please set the withdrawal length to be greater than the length of the wire