工藝:點焊功能的使用(魚鱗紋和間斷)(中英)

點焊功能對應的面板監測頁版本號為:330以上(含)

The version number of the panel monitoring page corresponding to the spot welding function is: 330 or above (inclusive)

一. 如何使用點焊功能

1.1 首頁啟用點焊模式

1.2 設置里面選擇點焊的類型(魚鱗紋/間斷)

1.3 設置里面設置合理的點焊持續時間和點焊間隔時間

二.點焊類型的參數和調試

首先,使用連續焊接來調試好工藝,再去啟用點焊功能選擇點焊類型

I. How to use spot welding function



1.1 Home Enable spot welding mode


1.2 Select the type of spot welding inside the setting (fish scale/break)


1.3 Settings Set reasonable spot welding duration and spot welding interval


Two. Spot welding type parameters and debugging


First, use continuous welding to debug the process, and then select the spot welding type by enabling the spot welding function





2.1魚鱗模式焊接

(在此模式下,間斷時只關激光,其他設置的參數如開關/關光時間不影響也不生效)

只需設置點焊持續時間和間隔時間即可產生魚鱗紋焊接效果,最低可設置1ms)

點焊持續時間:150ms(此參數影響焊接的紋狀大?。?/p>

點焊間隔時間:50ms(此參數影響兩個紋狀之間的間隔)

2.1 Fish scale mode welding


(In this mode, only the laser is turned off during the interruption, and other parameters such as switching/switching time do not affect or take effect)


Just set the spot welding duration and interval time to produce fish scale welding effect, the minimum can be set 1ms)


case


Spot welding duration: 150ms (this parameter affects the grain size of the weld)


Spot welding interval time: 50ms (This parameter affects the interval between the two grooves)



2.2間斷模式焊接

(在此模式下,間斷時關激光、關保護氣體、停止送絲。其他設置的參數如開關/關光時間影響也生效,。主要用于定長焊接

通過設置點焊持續時間來改變焊接長度,點焊間隔時間可設高一些

點焊持續時間:1000ms(此參數影響焊接長度,也就是出光的時間)

點焊間隔時間:5000ms(此參數可固定數值,默認為5000)

請注意,在此模式下,斷絲的時候需要人為的判定,及時上抬斷絲

2.2 Intermittent mode welding


In this mode, the laser is turned off, the protective gas is turned off, and the wire feed is stopped. Other parameters such as on/off light time are also affected. Mainly used for fixed length welding)


Change the welding length by setting the spot welding duration, and the spot welding interval can be set higher


case


Spot welding duration: 1000ms (this parameter affects the welding length, that is, the time of the light)


Spot welding interval: 5000ms (This parameter can be fixed, the default is 5000)


Please note that in this mode, human judgment is required to lift the broken wire in time




圖示: