工藝:焊接頭焊接的參數設置(中英)

一.參數的設置

首頁的焊接模式選擇:連續,并設置工藝,調整好需要的焦點

I. Parameter setting

Home welding mode selection: continuous, and set the process, adjust the required focus







二.信號的檢測

只有【激光器扳機信號】和【安全地鎖信號】有效時,才會出光(激光器狀態正常),同時首頁未出現任何報警

關于首頁的報警,多數是(設置)里面的報警電平設置錯誤,請更改對應的報警電平

Ii. Signal detection

Only when [laser trigger signal] and [safety lock signal] are effective, light will come out (laser state is normal), and there is no alarm on the home page

About the alarm on the home page, most of the alarm levels in the (setting) are wrong, please change the corresponding alarm level







三.紅光的調整

請務必紅光在中心,如有偏移,請參照:紅光的調整


四.銅嘴的選擇

請使用對應的銅嘴焊接,請參照:銅嘴分類

Three. Red light adjustment

Make sure the red light is in the center, if there is deviation, please refer to: Red light adjustment



Four. Choice of copper nozzle

Please use the corresponding copper nozzle welding, please refer to: Copper nozzle classification