工藝:焊接頭清洗的參數設置(中英)

超期偉業焊接頭的清洗參數設置

一.系統的接線

清洗版接線與焊接版沒有差別,可參考其接線部分:SUP20S說明書‍

(信號接口一的5/6腳短接,使其安全地鎖有效,扣動扳機按鈕后即出光)


二.工藝設置

Cleaning parameter setting of extended welding joint

I. Wiring of the system

There is no difference between the cleaning version and the welding version, you can refer to its wiring part: SUP20S manual ‍

(The 5/6 pin of signal interface 1 is shorted to make the safe lock effective, and the light comes out immediately after the trigger button is pulled)

2. Process setting



清洗工藝

掃描頻率:電機的擺動速度,范圍10-100Hz,建議設置50

掃描寬度:光板的掃描寬度,范圍0-150mm,建議設置150

占空比:默認100%

脈沖頻率:默認2000

設置參數后,導入并返回,即可在首頁的左側看到此工藝


②焦點的確認

通過來回近遠距離的掃描,在聲音最大,火花最大時即為焦點,此時應按照這個距離進行清洗,能量最強

(一般槍頭到板材的距離為30厘米左右能量最強)

Cleaning process


Scanning frequency: motor swing speed, range 10-100Hz, recommended to set 50


Scanning width: The scanning width of the light plate, the range is 0-150mm, 150 is recommended


Duty cycle: 100% by default


Pulse frequency: Default 2000


After setting the parameters, import and return, you can see the process on the left side of the home page


② Confirmation of focus


By scanning back and forth near and far, it is the focus when the sound is the largest and the spark is the largest, and it should be cleaned according to this distance and the energy is the strongest


(Generally, the distance between the gun head and the plate is about 30 cm, and the energy is strongest)






③信號的檢測

只有【激光器扳機信號】和【安全地鎖信號】有效時,才會出光(激光器狀態正常),同時首頁未出現任何報警

關于首頁的報警,多數是(設置)里面的報警電平設置錯誤,請更改對應的報警電平


清洗時請保持槍頭到板材的距離平穩,手速保持均勻

③ Signal detection


Only when [laser trigger signal] and [safety lock signal] are effective, light will come out (laser state is normal), and there is no alarm on the home page


About the alarm on the home page, most of the alarm levels in the (setting) are wrong, please change the corresponding alarm level


When cleaning, keep the distance from the gun head to the plate steady, and keep the hand speed even