手持焊接:紅光矯正(中英)

紅光偏配圖.jpg





因單擺電機,只可以軟件調整紅光左右(微調),不可以軟件調整上下,因此在特殊情況,需要使用機械調整

Because the pendulum motor can only be adjusted around the red light by software (fine tuning), it can not be adjusted up and down by software, so in special cases, mechanical adjustment is needed


1.軟件設置(左右調整)

通過設置界面的激光中心偏移來微調,依次是{1.設置}-{2.更改激光中心偏移數值,負值往右,正值往左,最新版本最大可調整數值+3/-3}。這種方案可以進行左右的微調,如果使用這種方法依然無法調整,則使用機械調整

1. Software Settings (left and right adjustments)

Fine-tune by setting the laser center offset of the interface, in order is {1. Set}-{2. Change the laser center offset value, negative to the right, positive to the left, the latest version of the maximum adjustable value +3/-3}. This scheme can be fine-tuned left and right, and if it is still impossible to adjust using this method, mechanical adjustment is used


2.機械調整(上下左右調整)

在進行機械調整前,請務必把設置的中心偏移設置為0


2. Mechanical adjustment (up, down, left and right)

Before making mechanical adjustments, be sure to set the center offset to 0




3.先看一下結構

3. Look at the structure first



C :擰松可以拿掉電機,一般擰松以后調整左右方向

A:包含兩側各一個螺絲,擰緊以后光往下(先弄兩側的螺絲

B:包含兩側各一個螺絲,擰緊以后光往上(先松兩側的螺絲

C: The motor can be removed by loosening, and the left and right direction can be adjusted after loosening

A: Including one screw on each side, after tightening the light down (screw on both sides first)

B: Including one screw on each side, after tightening, go up (loosen the screws on both sides first)





SUP20S機型的調整方法

Adjustment method of SUP20S model






假如:紅光已經完全無法從銅嘴里面出來,那么我們可以先看保護鏡,如下,優先調整【C】螺絲,然后在調整上下

If: the red light has been completely unable to come out of the copper mouth surface, then we can first look at the protective mirror, as follows, priority adjustment [C] screw, and then adjust up and down