激光器與控制盒的接線邏輯(中英)


一.控制盒的接線定義

控制盒提供了必要的硬線信號接口,根據激光器的說明書提供的定義匹配接線,以SUP20S手持焊接為例


One. Wiring definition of the control box


The control box provides the necessary hard-wired signal interface to match the wiring according to the definition provided in the laser's manual, taking SUP20S handheld welding as an example



如上圖所示,必要的三組信號為

2/4腳使能信號,工作時輸出24V電壓控制信號

4/5腳模擬量信號,工作時輸出額定的電壓控制信號(滿功率下10V輸出,輸出電壓為工藝的峰值功率除以(設置界面里的激光器的總功率除以10),假設激光器功率為2000,工藝峰值功率為1000,則輸出電壓為5V)

6/7腳為PWM調制信號,工作時輸出為24V


4號腳為使能.DA.3號腳的共用地?。?!


As shown in the figure above, the three necessary sets of signals are:


The 2/4 pin enables the signal, and outputs the 24V voltage control signal during operation


4/5 pin analog signal, output rated voltage control signal when working (10V output at full power, output voltage is the peak power of the process divided by (the total power of the laser in the setting interface divided by 10), assuming the laser power is 2000, the process peak power is 1000, the output voltage is 5V)


Pin 6/7 is a PWM modulation signal, and the output is 24V when working


Pin 4 is enabled. DA.3 Foot Common!!


.激光器的接線匹配

  任何激光器都需要以上三組信號,但廠商不同,接線定義不一樣,應按照激光器的邏輯進行接線

個別激光器需要觸發信號,如銳科個別型號的紅光觸發,恩耐激光器的控制模式的觸發,這些都是需要24V,應接在控制盒的3號腳


列如:銳科小體型激光器,首先看他的說明書提供的定義

Two. Wiring matching of the laser


Any laser needs the above three sets of signals, but different manufacturers have different wiring definitions, and the wiring should be routed according to the logic of the laser


(Individual lasers need trigger signals, such as the red light trigger of individual models of Ruike, and the triggering of the control mode of Ennai laser, which all require 24V, which should be connected to the No. 3 pin of the control box)


For example, Ruike small size laser, first look at the definition provided in his manual


在他們提供的定義中,使能+是18號腳,使能-是20號腳(18的返回端)

18接2

20接4

提供使能信號,以此類推,接線完成后,出光測試,如果激光器不出光,接激光器的監控看一下哪個信號沒有,然后做對應檢查


In the definition they provide, enable+ is pin 18 and enable- is pin 20 (the return end of pin 18)


rule


18 to 2


20 to 4


Provide an enable signal, and so on, after the wiring is completed, the light is tested, if the laser does not produce light, connect to the laser monitoring to see which signal is not there, and then do the corresponding check