飛博激光器與控制盒的控制接線(中英)

注意:

1.請確保文中的激光器圖示與您使用的激光器為同一型號 本文適用 YDFL-1000-CW 光纖激光器

2.如激光器廠家信號更改,則下列接線失效,請按照廠家提供的定義接線

Attention:


1. Please ensure that the laser diagram in the article is the same model as the laser you use. This article applies to YDFL-1000-CW fiber laser

2. If the laser manufacturer's signal changes, the following wiring fails. Please connect the wiring according to the manufacturer's definition





YDFL-1000-CW 光纖激光器圖示

Illustration of the YDFL-1000-CW fiber laser


外部控制信號接口(DB25)




根據以上定義,接線方式:


首先短接激光器DB25的1和4,2和3


(PWM信號)

DB25的15腳(外部觸發信號GATE)接控制盒的信號接口三的7號腳

DB25的16腳(GND_IO)接控制盒的信號接口三的6號腳


(模擬量給定)

DB25的12腳(IFWD_SET外部模擬量給定0-10V+)接控制盒的信號接口三的5號腳

DB25的14腳(CAST/返回端)接控制盒的信號接口三的4號腳


(使能信號)

DB25的18腳(EX_EN激光使能)接控制盒的信號接口三的2號腳

DB25的20腳(15-24的返回端)接控制盒的信號接口三的4號腳



(紅光觸發)

DB25的17腳(紅光)接控制盒的信號接口三的3號腳

According to the above definition, the wiring mode:


First short-circuit the 1 and 4,2 and 3 of the laser DB25


(PWM signal)


Pin 15 (external trigger signal GATE) of the DB25 is connected to pin 7 of signal port 3 of the control box


Connect pin 16 (GND_IO) of the DB25 to pin 6 of signal port 3 of the control box


(Analog quantity given)


Pin 12 of the DB25 (IFWD_SET external analog 0-10V+) is connected to pin 5 of signal interface 3 of the control box


Pin 14 (CAST/ return end) of the DB25 is connected to pin 4 of signal interface 3 of the control box


(Enable signal)


Connect pin 18 of the DB25 (EX_EN laser enabled) to pin 2 of signal port 3 of the control box


Pin 20 of the DB25 (return end of 15-24) is connected to pin 4 of signal interface 3 of the control box


(red light trigger)


Pin 17 (red light) of the DB25 is connected to pin 3 of signal interface 3 of the control box