IPG-14激光器與控制盒的控制接線(中英)

注意:

1.請確保文中的激光器圖示與您使用的激光器為同一型號 本文適用 YLR-14 型號

2.如激光器廠家信號更改,則下列接線失效,請按照廠家提供的定義接線

Attention:


1. Please make sure that the laser icon in the article is the same model as the laser you are using

2. If the laser manufacturer's signal changes, the following wiring fails. Please connect the wiring according to the manufacturer's definition





YLR-14 光纖激光器圖示①

Figure 1 shows the YLR-14 fiber laser







接線邏輯

1.首先短接Han24中的【1/4】【2/3】互鎖信號,【8/9】短接

2.其中【10/11】使用帶鎖按鈕①接常開腳,10/11導通

                                                                                                                           Wiring logic


1. First short-circuit the [1/4] [2/3] interlock signal in Han24, [8/9] short-circuit


2. Where [10/11] use the lock button ① to connect the normal opening pin, 10/11 conduction



激光器的12/14腳分別接控制盒信號接口三的5/4腳提供模擬量信號

激光器的15/16腳分別接控制盒信號接口三的7/6腳提供PWM調制信號

激光器的17/18腳一起接控制盒信號接口三的3號腳提供使能和紅光信號觸發,但由于是上升沿觸發,所以中間使用帶鎖的按鈕②接常開腳

激光器的20號腳為公用地,接控制盒的4號腳提供參考地


4.開機順序

激光器上電--按下帶鎖按鈕①--按下帶鎖按鈕②-正常焊接

The 12/14 pins of the laser are respectively connected to the 5/4 pins of the control box signal interface 3 to provide analog signals


The 15/16 pins of the laser are respectively connected to the 7/6 pins of the signal interface of the control box to provide PWM modulated signals


The 17/18 pin of the laser is connected to the No. 3 pin of the signal interface of the control box to provide enable and red signal trigger, but because it is triggered by the rising edge, a lock button (2) is used in the middle to connect the normal opening pin


The No. 20 foot of the laser is the public land, and the No. 4 foot of the control box provides the reference ground




4. Boot sequence


Power on the laser - press the lock button ①- Press the lock button ②- Normal welding