銳科C系X/H與控制盒的控制接線(中英)

注意:

1.請確保文中的激光器圖示與您使用的激光器為同一型號

2.如激光器廠家信號更改,則下列接線失效,請按照廠家提供的定義接線

Attention:


1. Please ensure that the laser icon in the article is the same model as the laser you are using

2. If the laser manufacturer's signal changes, the following wiring fails. Please connect the wiring according to the manufacturer's definition




銳科小體積RFL-C-X/H圖示

Illustration of RFL-C-X/H small volume of Rayco


激光器信號接口CTRL-INTERFACE定義(DB24)

Laser Signal Interface CTRL-INTERFACE Definition (DB24)






根據以上定義,接線方式:


1.首先短接激光器信號接口CTRL-INTERFACE(DB24)的2和3


2.DB24的12腳(模擬量+)接控制盒的信號接口三的5號腳

3.DB24的14腳(12.13的參考地)接控制盒的信號接口三的4號腳



4.DB24的15腳(調制信號MOD+)接控制盒的信號接口三的7號腳

5.DB24的16腳(調制信號MOD-的返回端)接控制盒的信號接口三的6號腳


6.DB24的18腳(使能)接控制盒的信號接口三的2號腳

7.DB24的17腳(外部供電)接控制盒的信號接口三的3號腳

8.DB24的21腳(高電平AD模式)接控制盒的信號接口三的3號腳

9.DB24的20腳(返回端)接控制盒的信號接口三的4號腳


According to the above definition, the wiring mode:


1. First, short-circuit 2 and 3 of the laser signal interface CTRL-INTERFACE(DB24)

2. Connect pin 12 (analog +) of the DB24 to pin 5 of signal interface 3 of the control box

3. Connect pin 14 of the DB24 (reference ground in 12.13) to pin 4 of signal port 3 of the control box

4. Connect pin 15 (modulated signal MOD+) of DB24 to pin 7 of signal interface 3 of the control box

5. Pin 16 of DB24 (return end of MODulated signal MOD-) is connected to pin 6 of signal interface 3 of the control box

6. Connect pin 18 (enabled) of the DB24 to pin 2 of signal port 3 on the control box

7. Connect pin 17 (external power supply) of the DB24 to pin 3 of signal port 3 of the control box

8.Connect pin 21 of the DB24 (high level AD mode) to pin 3 of signal interface 3 of the control box

9. Connect pin 20 (return end) of DB24 to pin 4 of signal interface 3 of the control box